Zelenograd, Savelkinsky proezd, 4, 6th floor
Russian measuring instruments and ATE systems
Contact form
    RUS

Bench tests

Bench tests

The bench testing system combines a set of software and hardware for the simultaneous registration, synchronization, processing and storage of large volumes of information flows from both electrical measuring equipment and visual observation equipment.
Collecting and recording data, testing gas turbine engines, and monitoring the testing process in real time.
Description
The bench testing system combines a set of software and hardware for the simultaneous registration, synchronization, processing and storage of large volumes of information flows from both electrical measuring equipment and visual observation equipment.

Collecting and recording data, testing gas turbine engines, and monitoring the testing process in real time.


Modular platform allows synchronization of measuring channels with high accuracy.


The system displays the engine test parameters on the operators' monitors in real time, quickly monitors emergency operating modes, continuously records data from the measuring channels, and can also perform post-processing (playback and analysis of the recorded data). In addition, during the testing process, system operators can generate and print protocols.

Scope

  • Simultaneous synchronous polling of a large number of measuring channels
  • Client-server architecture
  • High data logging rate
  • High measurement accuracy
  • High noise immunity of data transmission lines
  • Low cost price / channel
  • Duplicate data logging

Specification and characteristics

  • MFTK - current command generator; 2 input lines; 30 output lines; 200 V; 1 A
  • MFSK-24E - generator of impulse commands "dry contact"; 24 channels; 60 V; 2 A
  • MTD32-current meter; 32 channels; 0-20 mA; 302 μs sampling period
  • MDS32 - voltage meter; 32 channels; 0.1 ms polling rate; 10 in
  • MN8IP - voltage meter; 8 channels; 5 μs - sampling period; 10V; bandwidth 31 kHz
  • MDN8I - voltage meter; 8 channels; 1.6 μs - sampling period; 10V; bandwidth 240 kHz
  • МТМ8 - strain gauge signal meter; 8 channels; voltage reproduction - from 0.5 to 16 V; voltage measurement - ± 50 mV; deformation measurement - ± 40,000 µΕ; sampling period - 1.6 μs; bandwidth - 150 kHz;
  • MT16-4L - resistance meter; 16 channels; from 0.6 Ohm to 80 kOhm; sampling period 302.0 μs
  • MIRIG -reception, registration and synchronization of precise time signals of the IRIG-B DCLS, IRIG-B AM standards with a frequency of 1 kHz

Software    

INFORMTEST CAT

QT Registrator


Examples of ready-made solutions

TEST-1401 - Use in autonomous tests of drive control units
SIBS - Test facilities for on-board systems (SIBS)
TEST-4205-01 APS ASKA - Automated measuring system
TEST-4205-02 - Telemetry system for the automated control system of the spacecraft
TEST-3204 - Automated measuring system

SDI-16 - Complex for analysis of dynamic signals
TS-16 - 16 (or 8) channel LXI strain gauge station
THERMOSTATION VT-96

EIIS - Unified information and measurement system for bench tests
AIIS & SU - Automated control system of technological processes of the stand
SU-1101 - System for automated collection, real-time display of measurement information
Need some advice?
We will tell you in detail about our solutions, types of work and typical projects, calculate the cost and prepare an individual offer!
Ask a Question